修邊包裝線是花紋鋁板生產過程的一個道工序，鋁板生產廠家為您講解下其工藝流程具體內容。
The trimming and packaging line is a process in the production process of patterned aluminum plate, and the aluminum plate manufacturer will explain the specific content of its process flow for you.
1、定位:按花紋鋁板需要裁切尺寸，調整好定位裝置，合理確定各邊修邊量。
1. Positioning: according to the cutting size of figured aluminum plate, adjust the positioning device and reasonably determine the trimming amount of each side.
2、裁切:先將花紋鋁板置于縱切機上裁切長邊，然后再進入橫切裁切短邊。
2. Cutting: first place the figured aluminum plate on the slitter to cut the long side, then enter the cross cutting to cut the short side.
3、清掃:裁切完畢后，操作員用毛刷將板面清掃干凈，花紋鋁板堆放整齊。
3. Cleaning: After cutting, the operator shall clean the board surface with a brush, and the patterned aluminum plates shall be stacked neatly.

4、送到發運處:用叉車將花紋鋁板送到了至發運處，進行印字包裝。
4. Send to the shipping place: use a forklift to send the figured aluminum plates to the shipping place for printing and packaging.
5、貼標識:按工藝要求在成品板右下角粘貼產品合格證，品質保證和產品色標等標識。
5. Labeling: according to the process requirements, the product certificate, quality assurance, product color code and other identifications shall be pasted at the lower right corner of the finished board.
6、入庫:用叉車將成品板送入指定位置，并填寫產品入庫登記卡。
6. Warehousing: use a forklift to send the finished boards to the designated location, and fill in the product warehousing registration card.
花紋鋁板的修邊包裝線工藝流程就從6個步驟了解起來，您有什么問題可以隨時來我們這里http://www.ahxsxljk.com咨詢！
The process flow of the edging and packaging line of patterned aluminum plate can be learned from six steps. If you have any questions, you can come to us at any time http://www.ahxsxljk.com consulting service